When referring to the printout, check that the вЂњLink StatusвЂќ indicates вЂњActiveвЂќ and that the SSID - Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network. Press the button (A) repeatedly until the LED displays. Load a sheet of A4 or Letter-sized plain paper.ДЈ. Make sure that your printer is turned on.Дў. To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer:ДЎ. If you have more than one access point, press the button on only one access point. Please wait for a while, then conп¬Ѓgure WPS settings again. This error appears when multiple WPS access points are detected. Is the access point turned on? If the access point is already turned on, turn it off, and then turn it back on. This error appears when wireless connection setup was not completed within 2 minutes after pressing the WPS button.

If any of the following error codes are displayed on the LED (alternately flashing between the letter вЂњEвЂќ and then a вЂњNumberвЂќ followed by another вЂњNumberвЂќ), please press the or button to dismiss the error, and then repeat steps 1 and 2. Make sure that the (blue) Wi-Fi lamp on the printer is also lit. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to '1' as shown in the illustration below. The (blue) Wi-Fi lamp on the printer will п¬‚ash while searching for, or connecting to the access point.ДЈ. Make sure that the LED п¬‚ashes as shown in the illustration above, then press the button on your access point within 2 minutes.ДЇor exact details regarding pressing the WPS button, please refer to the access point manual. Make sure that the LED п¬‚ashes as shown in the illustration below.Дў. Press and hold the button (A) on the printer for approximately 5 seconds.Дў. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.ДЎ. Most WPS enabled access points use this protocol.

Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.If the WPS push button is not available please use the instructions in the Standard Connection Method section. Please check with your deviceвЂ™s user guide for details.

The access point must have a physical WPS push button available.Before we start, there are some conditions that must be met in order to use the WPS push button method:

Install canon ij on screen manual mac